-40%
RF Microwave Resistive Power Divider 1 to 3 Splitter/Combiner Female SMA (-10dB)
RF Microwave Resistive Power Divider 1 to 3 Splitter/Combiner Female SMA (-10dB)
RF Microwave Resistive Power Divider 1 to 3 Splitter/Combiner Female SMA (-10dB)
RF Microwave Resistive Power Divider 1 to 3 Splitter/Combiner Female SMA (-10dB)
RF Microwave Resistive Power Divider 1 to 3 Splitter/Combiner Female SMA (-10dB)
RF Microwave Resistive Power Divider 1 to 3 Splitter/Combiner Female SMA (-10dB)
RF Microwave Resistive Power Divider 1 to 3 Splitter/Combiner Female SMA (-10dB)

RF Microwave Resistive Power Divider 1 to 3 Splitter/Combiner Female SMA (-10dB)

$ 7.38

Availability: 100 in stock
  • Brand: Robert's Research & Radios
  • All returns accepted: ReturnsNotAccepted
  • Condition: New
  • Type: Power Divider
  • Connector Style: 4-Port
  • MPN: N/A

    Description

    This RF resistive power divider will allow you to connect multiple outputs to a single input or to combine 2 RF signals into a single output at frequencies ranging from DC to >3 GHz (Performance will be significantly degraded at about 6 GHz). Resistive power dividers are perfect for sharing an LO signal in a vertically integrated mixer setup or for providing an amplified RF input signal to multiple SDRs. Device can be used with less than 4 ports, but unused ports must have 50 Ohm terminations for proper performance. Possible setups are shown below:
    *pictures needed*
    RF microwave resistive power divider Assembled in the USA
    50 Ohm grounded coplanar waveguide board traces
    1/2 watt max power rating (made using 1/4 Watt 2012 metric SMD components)
    Board-fitting edge-mount Samtec female SMA connectors
    Tested up to 3GHz with VNA for input/output matching and insertion loss characteristics relative to 50 Ohms
    4x 3.2mm Diameter Mounting Holes
    SMA connectors soldered by hand to back side of board for strength and durability